How to resolve AdBlock issue? × Questions concerning iron and steel, steel making, rod rolling, galvanizing, springs, nails, fencing, and patenting go here.
Under size and over size problem
- Archived Forum Admin
-
Topic Author - Offline
- Platnium Boarder
-
Less More
12 years 10 months ago #853 by Archived Forum Admin
Under size and over size problem was created by Archived Forum Admin
Dear All,
I am working on wire under size and over size project from last 2 months but i could not understand the root causes behind that problem.I use 5.5 mm high carbon wire rod my finish size is 0.92 (C-.84/.71/0.67) please help me in this matter
Thanks
I am working on wire under size and over size project from last 2 months but i could not understand the root causes behind that problem.I use 5.5 mm high carbon wire rod my finish size is 0.92 (C-.84/.71/0.67) please help me in this matter
Thanks
Please Log in to join the conversation.
- Archived Forum Admin
- Topic Author
- Offline
- Platnium Boarder
-
12 years 10 months ago #854 by Archived Forum Admin
Replied by Archived Forum Admin on topic Re: Under size and over size problem
Could you please give more detail information about what the actual problem is?.
Eduardo Anaya
Senior Consultant
INDEPA S.C.
Mexico City
Tel(011-52)555-407-7451
This email address is being protected from spambots. You need JavaScript enabled to view it.
Eduardo Anaya
Senior Consultant
INDEPA S.C.
Mexico City
Tel(011-52)555-407-7451
This email address is being protected from spambots. You need JavaScript enabled to view it.
Please Log in to join the conversation.
- Archived Forum Admin
- Topic Author
- Offline
- Platnium Boarder
-
12 years 10 months ago #855 by Archived Forum Admin
Replied by Archived Forum Admin on topic Re: Under size and over size problem
Agree with Eduardo, need more information, like drafting schedule as well as die angles. What type of machine are you using and is cooling adequte and also what type of lubrication are you using, sodium or calcium.
Axeman
Axeman
Please Log in to join the conversation.
- Archived Forum Admin
- Topic Author
- Offline
- Platnium Boarder
-
12 years 10 months ago - 12 years 7 months ago #856 by Archived Forum Admin
Replied by Archived Forum Admin on topic Re: Under size and over size problem
To have both under size and oversize can mean a lot of things. undersize could be tension, die packing, etc. oversize could be excessive die wear. There are many variables that could be causing your problems but if you want some suggestions, you need to provide a lot more information.
Last edit: 12 years 7 months ago by Archived Forum Admin.
Please Log in to join the conversation.
Moderators: Peter J Stewart-Hay, Eduardo Anaya, Peter M Power
Time to create page: 0.113 seconds