How to resolve AdBlock issue? 
- Posts: 2
- Thank you received: 0
× If you have a question regarding coaxial, telephone, and building wire, power cable, insulation, extrusion, bunching, stranding, braiding, etc. post it here.
Installation in conduit?
- Ms Anna Ingham
- Topic Author
- Offline
- Fresh Boarder
-
Less More
9 years 3 months ago #2888 by Ms Anna Ingham
Installation in conduit? was created by Ms Anna Ingham
Should quad shield RG6 digital cable be installed in conduit if out exposed to the elements on a hot/cold tin roof? It is for a TV antennae installation.
Please Log in to join the conversation.
- Peter J Stewart-Hay
- Offline
- Moderator
-
Less More
- Posts: 126
- Thank you received: 21
9 years 3 months ago #2889 by Peter J Stewart-Hay
Regards,
Peter J. Stewart-Hay Principal
Stewart-Hay Associates
www.Stewart-Hay.com
This email address is being protected from spambots. You need JavaScript enabled to view it.
Replied by Peter J Stewart-Hay on topic Installation in conduit?
Hello Ms Ingham,
Your cable as you have stated, would be outside and exposed to the elements including lightning. It would also be mounted on a metallic roof.
I personally would be quite cautious and install the cable in a small metallic conduit with the upper end sealed to prevent moisture ingress. The lower end of the conduit would be left open to drain any moisture that inadvertently got into the conduit. Moreover, I would make sure that the metallic roof, TV antenna and conduit are all properly grounded.
Finally, I would make sure to use moisture proof connectors on the cable.
Your cable as you have stated, would be outside and exposed to the elements including lightning. It would also be mounted on a metallic roof.
I personally would be quite cautious and install the cable in a small metallic conduit with the upper end sealed to prevent moisture ingress. The lower end of the conduit would be left open to drain any moisture that inadvertently got into the conduit. Moreover, I would make sure that the metallic roof, TV antenna and conduit are all properly grounded.
Finally, I would make sure to use moisture proof connectors on the cable.
Regards,
Peter J. Stewart-Hay Principal
Stewart-Hay Associates
www.Stewart-Hay.com
This email address is being protected from spambots. You need JavaScript enabled to view it.
The following user(s) said Thank You: Ms Anna Ingham
Please Log in to join the conversation.
- Ms Anna Ingham
- Topic Author
- Offline
- Fresh Boarder
-
Less More
- Posts: 2
- Thank you received: 0
9 years 3 months ago #2891 by Ms Anna Ingham
Replied by Ms Anna Ingham on topic Installation in conduit?
You have been most helpful. Thank you.
Please Log in to join the conversation.
Moderators: Erik A Macs, Peter J Stewart-Hay
Time to create page: 0.093 seconds