How to resolve AdBlock issue? × Nonferrous topics such as copper and aluminum, annealing, etc. go here.
Copper Annealing Wipes
- Archived Forum Admin
-
Topic Author - Offline
- Platnium Boarder
-
Less More
12 years 10 months ago #1419 by Archived Forum Admin
Replied by Archived Forum Admin on topic Re: Copper Annealing Wipes
Do you think I should move the 2nd (exterior) air wipe inside of the annealer housing. As of now, the air wipe is about 30 feet away from the annealer.Hitting the wire with air sooner than later would decrease my chances of oxidation?
KJC
KJC
Please Log in to join the conversation.
- Archived Forum Admin
- Topic Author
- Offline
- Platnium Boarder
-
12 years 10 months ago #1420 by Archived Forum Admin
Replied by Archived Forum Admin on topic Re: Copper Annealing Wipes
Hello,
Don't worry about oxidation as your wire should be cold but remember that there can be water on the inner surface of the frame of the annealer. Mount the air wipe (which uses dry, clean air) in a position so that water cannot drip or splash back on to the wire. (IE) Where the wire exits the frame of the annealer.
Regards
Peter J. Stewart-Hay
Principal
Stewart-Hay Associates
www.Stewart-Hay.com
519 641-3212
Don't worry about oxidation as your wire should be cold but remember that there can be water on the inner surface of the frame of the annealer. Mount the air wipe (which uses dry, clean air) in a position so that water cannot drip or splash back on to the wire. (IE) Where the wire exits the frame of the annealer.
Regards
Peter J. Stewart-Hay
Principal
Stewart-Hay Associates
www.Stewart-Hay.com
519 641-3212
Please Log in to join the conversation.
Moderators: Erik A Macs, Peter J Stewart-Hay
Time to create page: 0.075 seconds